Click anywhere to close.
Click anywhere to close.
 |
You are here: Home > Print and Apply > Print Engines > Sato LT408 |
You can equip your print-apply system with a printer module Sato® LT408. On our labeling application systems, you just need to tight a few screws (standard drillings), connect the cable on the applicator port, select one of the application modes in the printer's menu and it's done.
The model LT408 from Sato® was created with cost reductions in mind. For this reason, the printers included the minimum indispensable and only allow a few options. However, the quality and functionality is assured, with 203dpi resolution printheads, possibility of choosing one communication port (after all, people only use one) and it even has the ribbon system factory installed. Available in LH and RH (left-/right-hand) variants, the printers LT408 have the following features:
Do not forget to check the extras that you would like to install. The most popular options for these printers are (some options can't be installed at the same time):
 |
The specifications shown on this page may vary depending on the versions/models of the systems and may contain errors and/or may be subject to future changes. Double check these specs with the ones available on the respective brochures/technical sheets and always mention the critical requirements of your particular application when ordering/inquiring for prices. |
